Автор Тема: Method of setting the stone crusher outlet  (Прочитано 239 раз)


  • Jr. Member
  • **
  • Сообщений: 69
    • Просмотр профиля
Method of setting the stone crusher outlet
« : Март 12, 2018, 12:25:28 pm »
The outlet adjusting range in product performance parameter Ore Milling Equipment table refers to the loose edge outlet. The longest distance between fixed jaw plate and the bottom of moving jaw plate is called loose edge outlet, usually refers to the directly measured distance in the process of jaw sledger downtime. Stone crusher outlet is the most important parameters of crusher, because it had decided the crusher ability and maximum size of the broken products. Therefore, every operator has to know how to measure crusher outlet.
The measurement method for European Ore Milling Equipment outlet has three kinds; they are depended on the jaw plate shape and the crusher type. Crusher outlet must be measured in a straight line in the bottom of crushing cavity. Discharging mouth measurement must be far away from the worn parts. Unless we otherwise note, at all times should abide by the minimum outlet the crusher allowed. Don't obey these recommended may cause jaw plate use efficiency is low (high scrap rate) or shorten crusher life. In addition, in less than the minimum allowed outlet conditions the operation will make crusher guarantee is invalid. The largest size of mixed iron (reinforced, bucket tooth, etc) must be smaller than crusher tight edge outlet (the shortest distance between the fixed jaw plate and moving jaw plate bottom).
In the Ore Milling Equipment stone production line, there are a few mining equipment used in the line, including the vibrating screen, jaw crusher, impact crusher or cone crusher, vibrating screen, belt conveyor etc. 1. Vibrating feeder: The vibrating feeder is used to feed the massive, granular materials evenly and continuously from the silos into the jaw crusher, meanwhile, it also can pre-screen materials. This equipment is widely used in metallurgy, coal, beneficiation, building material, chemical industry, grinding, etc